Electrical Assembler

Job TitleShift Hours: 6:00am - 2:30pm Monday - Friday. Overtime may exceed these hours at times and can be mandatory.ResponsibilitiesAssemble, fit, and mount sub-assemblies, components, and standard and near-standard fixed assemblies in Motor Control Centers, Enclosed Control, and related assemblies and sub-assemblies.Perform assembly required for test preparation and final inspection.Assemble and wire units, relay panels, panel boards, space heaters, and control panels.Bend and install power cable and leads, fabricate pre-cable unit, panel, and MTB harnesses, and power leads.Use established power checking procedures and equipment to verify electrical/mechanical integrity of units assembled.Stage parts for customer orders.Work from oral or written instructions, inspection reports, manufacturing information sheets, and wiring diagrams.Determine necessary parts, write requisitions, and obtain materials from stock areas.Assemble and fit parts and components to form sub-assemblies or completed assemblies.Make adjustments to ensure correct alignment and clearances.Install units, pan assemblies, and cover up steel, meters, kirk keys, pull boxes, reactors, relays, fuses, MTB assemblies, panel boards, space heaters, transformers, etc., by mounting/bolting into place.Make pre-bent cable unit, MTB, and control panel harnesses using pre-cable boards, control panels, and hand crimp lugs if necessary.Cut, install, and connect wire and/or cable in units where circuitry requires additional relays, timers, fuses, etc.Modify standard assemblies or doors as received, using hand or power tools.Make wiring changes as required and perform necessary mechanical repairs.Use a floor-operated overhead crane and jib cranes to move units, harnesses, device panels, etc., from one area to another.Mark wires, devices, or terminals as required and maintain records.Stage necessary component parts/materials for smooth order activities flow through the assembly/manufacturing process.RequirementsHigh school diploma/GED required.Manufacturing or production experience preferred.Ensure compliance with applicable systems and programs such as ISO 9000-2000, ISO 14001, Underwriters Laboratory, NEMA, etc.Determine the quality of work and report problems to area supervisor or Quality Control personnel.Read shop orders and drawings to determine assembly procedures.Wear all safety equipment and observe all hygiene requirements as specified and directed.Maintain equipment and work areas in a clean and orderly manner.Health and Safety ResponsibilitiesKnow and follow established job-specific and facility-wide health and safety procedures and rules.Bring health and safety issues to management's attention or correct those they can.Actively participate in accident, injury, and illness prevention activities.Identify and correct hazards and unsafe conditions.Maintain housekeeping in the work area.Maintain health and safety equipment in good working order.Participate actively in health and safety training and demonstrate competency based on training received.Participate actively in providing suggestions for health and safety program improvement.